Nuvite introduces GlazPFS PolyFluro Sealant to maintain a super high gloss “show quality” finish for paint in new or excellent condition. In addition, the PolyFluoro Sealant layer gives a hard shine surface that resists environmental effects to maintain the gloss and color against the effects of airborne chemicals and ultraviolet radiation. GlazPFS can also be used as a final step for maximum protection for the surface gloss and color after using NuPol SS or PowerPol II drywash cleaner/polishes.
With regular GlazPFS use, a surface barrier is maintained that will resist dirt staining and makes the surface easy to clean. GlazPFS is simple to use and avoids complicated setups and special application or buffing equipment.
Nuvite’s research to find a polyfluoro compound that will actually adhere to the surface at room temperature has produced a truly effective and technologically advanced product in Nuvite GlazPFS – the best thing you can do to maintain and protect your near-new or “new-looking” paint.

Specifications:
Appearance: -off white liquid
Odor: -mild
pH -10.6-10.8 @ 25 degrees C
Solubility: -dispersible in water
Specific Gravity: -0.961 @ 25 degrees C

Availability:
Quart, 1 & 5 Gallon or 15, 20, 30 and 55 Gallon Drums

Effects on Materials:
Nuvite GlazPFS will provide extreme gloss and superior “staying power” vs. waxes and other polymers. It will give the paint the maximum protection from dulling and oxidation without damage to underlying structures, windows or bright metal. However, high speed powered buffing tools are not recommended unless tested prior to general use in an inconspicuous area of the vehicle. Will not harm plastic trim, acrylic or polycarbonate lenses.

Health and Safety:
Nuvite NuGlaze with PFS* is not environmentally restricted. Users should use standard safety precautions, such as wearing gloves and eye protection along with any other standard safety procedures. Refer to Material Safety Data Sheet for further information.

Directions for Use:
(GlazPFS is intended for new condition, clean surfaces. If paint has any oxidation or needs surface cleaning, Nuvite recommends the use of an appropriate drywash paint restoration with Nuvite NuPol SS or a drywash cleaning with PowerPol II cleaner/polish prior to GlazPFS application.)
For Clean, Near-New or Excellent Condition Surfaces: Apply GlazPFS “as-is” to clean cotton flannel detailing cloth or smooth cotton towel and spread over a small enough area to be continuously worked so dry spots do not form. Work material evenly onto surface and continue to wipe the covered area until material appears to be gone, then move to next area. Do not allow wet material to dry or to form a white haze on the surface during application procedure. Allow covered area to set up (usually no more than 5-20 minutes depending on humidity conditions). Final buff to shine with clean dry terry towel (turn cloth frequently) or mophead (lifting frequently to reposition fibers).
For Normal or Lightly Soiled or Slightly “Aged” Surface Conditions: Prepare surface with Nuvite PowerPol II drywash surface cleaner prior to application of GlazPFS. Buff surface completely free of PowerPol II haze by hand with clean, dry towel or with clean, dry mophead before applying GlazPFS. Follow with application of GlazPFS procedure above.
For Heavily Soiled or Dulled Surface Conditions: For grease, oil, hydraulic oil buildup, or dulled paint gloss, it is recommended that a full surface restoration & cleaning with Nuvite degreasing products if needed, and NuPol SS cleaner be utilized prior to the use of PowerPol II or GlazPFS then proceed as above, depending upon paint surface condition.
Contact Nuvite representatives for further information and assistance, if required.