Nuvite's citrus-based CitriCut Gel wetwash uses it's fluid viscosity to cling to vertical and overhead surfaces, and it provides increased wet-out time and penetration of stubborn dirt or caked grease. CitriCut Gel extends Nuvite's extremely popular CitriCut formulation and its exceptional cleaning capabilities to even the most difficult situations. It also allows longer wet time for all surfaces even when used with water dilution. Water dilution may still be used if needed, or, for heavy cleanup, such as wheel wells and bellies.

CitriCut Gel can be used at full concentrate strength by applying with a low pressure spray, let soak, and spray rinse clean with high pressure. All these capabilities come without worry of paint, acrylic or airframe damage, and it is safe for users and the environment. It smells good, too!

Specifications:
Appearance: -orange, gel liquid
Flash Point -none
Odor: -mild Citrus Orange
pH 11.8-12.2 @ 25 degrees C
Solubility: dispersible
Specific Gravity: 1.02 @ 25 degrees C

Availability:
1 & 5 Gallon or 15, 20, 30 and 55 Gallon Drums

Effects on Materials:
Nuvite CitriCut Gel conforms to the requirements of
·Douglas CSD #1 · Boeing D6-17487 ·
for safety to bare and clad 2024, 7075, 2524 aluminum, cadmium
plated steel, mild steel, high-strength steel, Plexiglas, and paint.

Health and Safety:
Users should wear gloves and goggles along with other standard safety procedures. Refer to CitriCut Gel Material Safety Data Sheet
for further information.

Directions for Use:
CitriCut Gel is recommended for the periodic cleaning of exterior aircraft surfaces in dilutions determined by the extent, condition and type of soil to be removed.

Heavy-Duty Cleaning/Gear, Wheel Wells, Flaps, Cowlings: Use full strength concentrate. Viscosity can be adjusted with liquid CitriCut if desired. Allow to soak (5-15 minutes). Do not allow soaked area to completely dry. Rinse with high pressure water.

For Normal Cleaning - Wet Wash: Dilute 1:2-1:8 with water, depending upon soil conditions and cleaning frequency. Apply to aircraft surfaces by spray or mop application. Allow to soak long enough to loosen and emulsify surface dirt. Agitate to loosen soil and rinse with water.

Vertical or overhead surfaces: Spray full strength on surface with low pressure spray. Allow to soak-CitriCut Gel will cling and penetrate soil and grease. Agitate to loosen and spray rinse with high or low pressure water.

When using Nuvite materials, please refer to the appropriate procedures and recommendations for use and equipment, or call your Nuvite representative.